Arnott Electronic Bypass Module Installation Instructions

The Arnott Electronic Bypass Module is an innovative device designed to eliminate fault codes and warning lights, as well as maintaining the functionality of the air suspension system. The installation process is simple, and this guide aims to provide step-by-step instructions for a successful installation. Here’s what you’ll need:

• The Arnott Electronic Bypass Module

• Basic set of tools, including screwdrivers and pliers

• A flat surface to work on

• Safety glasses

Step One: Locate the Air Suspension Control Module

The first step in installing the Arnott Electronic Bypass Module is to locate the air suspension control module. This module is usually located under the passenger side dashboard or in the trunk, depending on the make and model of your vehicle. Refer to your vehicle’s owner’s manual for specific instructions on locating this module. Once you have located the module, disconnect the negative battery cable to ensure your safety.

Step Two: Remove the Air Suspension Control Module

Use a screwdriver or pliers to gently disconnect the wiring harnesses or plugs connected to the module. After disconnecting the wire harnesses, remove the control module from the vehicle by unscrewing the retaining bolts or clips, and set it aside for later use.

Step Three: Connect the Arnott Electronic Bypass Module

Next, connect the Arnott Electronic Bypass Module into the wiring harness or plug that was previously connected to the air suspension control module. The Arnott Electronic Bypass Module is designed to fit right into the place of the old module, making it an easy and seamless installation. Ensure that all wires are correctly connected to the module and are securely fastened to prevent any potential damage.

Step Four: Reinstall the Air Suspension Control Module

After connecting the Arnott Electronic Bypass Module, reinstall the air suspension control module by securing it in place with the retaining bolts or clips that were previously removed. Reconnect all of the wire harnesses or plugs by following the diagram provided in the installation manual. When you’re done, double-check all of the connections to make sure that everything is tightly secured.

Step Five: Power Up the System

With all of the wiring now reconnected, it’s time to power up the system. Reconnect the negative battery cable and start the vehicle. Observe the system for a few moments to ensure there is no warning light or fault code error messages. If everything appears to be working correctly, you have successfully installed the Arnott Electronic Bypass Module.

Closing Thoughts

Overall, the Arnott Electronic Bypass Module is an easy-to-use device that can save you a lot of money on trips to the mechanic. With this device installed, you can maintain the functionality of your air suspension system without having to worry about fault codes or warning lights. Follow these installation instructions closely to ensure a seamless installation process.